BT In Touch 2000 - Manual (Page 16)

16
User
Phone
&
P
endant
Important
The BT In Touch 2000 package is only completely
operational once both phones, the BT In Touch
Pendant and certain network services have been
successfully installed and the whole system has been
tested. We recommend that you install the BT In
Touch 2000 User Phone and BT In Touch Pendant
first, and then install the BT In Touch 2000c
Carer Phone (having subscribed to a Caller
Display network service). You should then test the
complete system (once all emergency numbers have
been allocated - see ‘Giving emergency status to
numbers’ on page 22).
1 Plan where you will put your
BT In Touch 2000 User Phone
Ideally you should site the BT In Touch 2000
User Phone in the room where the User will
spend most of their time. This will ensure they
can hear the voice announcements, either during
normal use or in an emergency, and especially
when operating in ‘handsfree’. The phone should
be within 2 metres of a phone socket.
Warning
Your BT In Touch is only designed to operate in a
normal domestic environment, with the exception
of the BT In Touch Pendant which is waterproof.
2 Install (or replace) the batteries
You must fit the batteries supplied before you
attach the base stand for either raised or wall-
mounted positions.
Warning
Before installing (or replacing) the batteries, the
phone must be disconnected from the phone line
and the mains power.
Setting up your BT In Touch 2000
User Phone
Please follow all the steps in the order shown.