Multiquip DCA85SSJU - Manual (Page 50)

PAGE 50 — DCA-85SSJU — PARTS AND OPERATION MANUAL — REV. #2 (12/21/01)
DCA-85SSJU — GENERATOR START-UP PROCEDURE (AUTO)
Before connecting this generator to any
building’s electrical system, a licensed
electrician must install an isolation
(transfer) switch. Serious
injury or death
may result without this transfer switch.
CAUTION:
When connecting the generator to a
isolation (transfer) switch, ALWAYS have
power applied to the generator's internal
battery charger. This will ensure that the
engine will not fail due to a dead battery.
CAUTION:
Starting the generator in the "AUTO" mode is similar to
starting the generator in the "MANUAL" mode, with a few
exceptions.
When running the generator in the AUTO
mode, remember the generator can start
up at any time without warning. NEVER
attempt to perform any maintenance
when the generator is in the auto mode.
3. Continue to follow the steps outline in the manual start-
up procedure (start at step 12, page 50).
CAUTION:
When starting generator in Auto mode use the "Manual Start-
up" procedure except where noted (see below).
1. Perform steps 1 through 10 (Before Starting, page 47-
48) as outlined in the manual starting procedure.
2. Place the Off/Manual/Auto switch (Figure 61) in the
AUTO position .
Figure 61. Off/Manual Auto Switch (AUTO)