Multiquip DCA85SSJU - Manual (Page 35)

DCA-85SSJU — PARTS AND OPERATION MANUAL— REV. #2 (12/21/01) — PAGE 35
How to read the output terminal gauge.
The gauge and knobs on the control panel DO NOT effect
the generator output . They are to help observe how
much power is being supplied produced at the UVWO
legs.
When the Voltage selector switch is in the 240/120V
position (see Figure 15), place the AC Voltmeter Change-
over switch to the W-U position and the AC ammeter
Change -over Switch to the U or W position to read the
output on the selected leg.
A
0
40
60
75
20
FIGURE 15. Voltage Selector Switch 240/120V Single Phase
Position
FIGURE 16. AC Voltmeter
Change-over switch
(Reading the W-U leg on
the outputerminal panel)
FIGURE 19. AC Ammeter
(Amp reading on U lug)
FIGURE 18. AC Ammeter
Change-over Switch
(Reading the U leg on the
output terminal panel)
FIGURE 17. AC Voltmeter
Gauge
(Volt reading on W-U Lug)
When using plural single phase
voltages, make sure to balance
the load on each of the single
phase legs.
NOTE
DCA-85SSJU — OUTPUT TERMINAL PANEL OVERVIEW