Generator shut-down procedures – Multiquip DCA20SPXU2 User Manual

Page 34

page 34 — dCa20spxu2 servpro

• operation and parts manual — rev. #0 (09/23/13)

normal sHutdoWn proCedure

To shutdown the generator, use the following procedure:

1. Place the

main, g.F.C.i., and aux. circuit breakers

(Figure 38) in the

OFF position.

Figure 38. Main, Aux. and GFCI

Circuit Breakers (OFF)

2. Let the engine cool by running it at low speed for 3-5

minutes with no load applied.

Warning

never stop the engine suddenly except in an

emergency.

generatOr shut-DOWn prOceDures

3. Place the

mpeC Control switch (Figure 39) to the

oFF/reset position.

Figure 39. MPEC Control Switch (Off/Reset)

4. Verify that

all the status LEDs on the MPEC display

are

OFF (not lit).

5. Remove all loads from the generator.
6. Inspect entire generator for any damage or loosening of

components that may have occurred during operation.

emergenCY sHutdoWn proCedure

1. Place the

main, g.F.C.i., and aux. circuit breakers

(Figure 38) in the

OFF position.

AUTO

MANUAL

OFF/RESET