Multiquip 900HD~2600HD - Manual (Page 10)

page 10 — FLeXSHaFTS/VIBRaTOR HeaDS • OpeRaTIOn anD paRTS manuaL — ReV. #0 (07/16/10)
specificatiOns
Table 4. Drive motors (electric/gasoline)
model# amps Voltage/Frequency Hp (kW) Rpm
Required
Shaft
Type
CV1 10 120 VAC 50/60 Hz 1 (1.2) 16,000 314V Electric
CV2 15 120 VAC 50/60 Hz 2 (1.8) 18,000 382V/FS Electric
CV2E 7.5 240 VAC 50/60 Hz 2 (1.8) 18,000 382V/FS Electric
CV3 20 120 VAC 50/60 Hz 3 (2.4) 19,250 382V/FS Electric
CV3E 10 240 VAC 50/60 Hz 3 (2.4) 19,250 382V/FS Electric
G55H N/A N/A 4.8 (3.6) 3,600 382V/FS Gasoline
BP25H N/A N/A 2.1 (1.6) 7,000 382V/FS Gasoline
NOTICE
Vibration techniques, vibrator head placement and
spacing as referenced in the "General Information" and
"Operation" sections of this manual is only to be used
as a guidline. Multiquip assumes no responsibility for
vibrator operating techniques referenced in this manual.
The consoldation of concrete has many mitigating
factors that must be considered such as slump, mix,
depth of vibrator, vibrator spacing, vibration time,
vibration frequency, temperature. All of these factors
must be considered when the consildation (vibration)
of concrete is required.