Multiquip C42H - Manual (Page 18)

PAGE 18 — C-4 FINISHER WALK-BEHIND TROWEL— PARTS & OPERATION MANUAL — REV. #0 (07/24/02)
C-4 FINISHER TROWEL — ASSEMBLY
Quick Pitch™ Handle Assembly
The C-4 finisher trowel is equipped with a folding upper handle
(Figure 4). It was assembled at the factory and shipped in its
folded or stow position. You will need to unfold and adjust the
trowel handle to the upright position prior to operation.
Considerable force may be
required when moving the
Quick Pitch
™ handle forward
or backward.
Unfolding the Trowel for Operation
1. Make sure that the Quick Pitch™ handle has been
attached to the upper handle bar and the pitch control cable
has slack. Remove the
T-handle knob from the swing bolt
on the top side of the upper handle bar, by rotating the
knob counter-clockwise. Move the Quick Pitch™
handle
toward's the operator's position and unfold the upper
handle bar away from the engine into the
upright position.
Re-insert the swing bolt so that it fits through the slot in the
hinge plate. Turn the T-handle knob counter-clockwise
securely to hold upper handle bar in place.
Figure 5. Trowel Folded and Operational
Positions
NOTE
FOLDED
POSITION
OPERATIONAL
POSITION
T-HANDLE
KNOB
UPPER
HANDLE