Multiquip EHTX44Y5 - Manual (Page 18)

page 18 — eHTx44y RIDe-ON TROWeL • OpeRaTION maNuaL — Rev. #0 (01/16/13)
cOntrOlS anD inDicatOrS
Figure 3. EHTX Controls and Components (Rear)
30
20
24
23
26 27
25
28
29
29
31
21 22
20. Documentation Box – Storage for documentation
and other information regarding the trowel.
21. Battery – Provides +12V DC power to the electrical
system.
22. Hydraulic Oil Sight glass – Indicates the level of the
hydraulic oil in the reservoir.
23. Hydraulic Suction Filter – Filters hydraulic fluid prior
to entering the system. (10 Micron absolute synthetic
media.)
24. Hydraulic Oil expansion Tank – Accommodates
expanding hydraulic oil as it gets hot. The oil gravity
flows back to the reservoir as it cools down, therefore
NeveR open the the Hydraulic Oil Filler Cap (Item 30)
when the system is warm and the oil has expanded.
25. Steering Control (Left Side) – Allows the unit to move
in a forward or reverse direction only.
26. Blade pitch Control Switch (Left Side) – Adjusts the
left side blade pitch independently of the right side.
27. Blade pitch Control (Twin pitch)™ – Adjusts the
blade pitches simultaneously.
28. Steering Control (Right Side) – Allows the unit to
move in either a forward, reverse left or right direction.
29. grill guards (Left and Right) – Protects operator from
moving components. Remove for maintenance access.
30. Hydraulic Oil Filler Cap – Remove this cap to add
hydraulic oil. Open ONLy when system is cooled down
and all expanded oil has returned to the reservoir.
31. Retardant Spray Tank – Holds 5 gallons of retardant,
water, or other liquid.
WaRNINg
Engine components can generate extreme
heat. To prevent burns, DO NOT touch
these areas while the engine is running
or immediately after operating. NeveR
operate the engine with the muffler removed.