beautypg.com

Safety information – Multiquip EHTX44Y5 User Manual

Page 10

background image

page 10 — eHTx44y RIDe-ON TROWeL • OpeRaTION maNuaL — Rev. #0 (01/16/13)

SafetY infOrMatiOn

TROWeL SaFeTy

DaNgeR

„

Engine fuel exhaust gases contain poisonous carbon

monoxide. This gas is colorless and odorless, and can

cause death if inhaled.

„

The engine of this equipment requires an adequate free

fl ow of cooling air.

NeveR operate this equipment in any

enclosed or narrow area

where free fl ow of the air is

restricted. If the air fl ow is

restricted it will cause injury

to people and property and

serious damage to the

equipment or engine.

„

NeveR operate the equipment in an explosive

atmosphere or near combustible materials. An

explosion or fi re could result causing severe

bodily harm or even death.

WaRNINg

„

If applicable,

NeveR use your hand to fi nd

hydraulic leaks. Use a piece of wood or

cardboard. Hydraulic fl uid injected into the

skin must be treated by a knowledgeable

physician immediately or severe injury or

death can occur.

„

aLWayS keep clear of rotating or moving

parts while operating the trowel.

„

NeveR disconnect any emergency

or safety devices. These devices are

intended for operator safety. Disconnection of these

devices can cause severe injury, bodily harm or even

death. Disconnection of any of these devices will void

all warranties.

CauTION

„

NeveR allow passengers or riders on the trowel during

operation.

„

NeveR lubricate components or attempt service on a

running machine.

„

NeveR place your feet or hands inside the guard rings

while starting or operating this equipment.

DANGEROUS

GAS FUMES

NOTICE

„

aLWayS keep the machine in proper running condition.

„

Fix damage to machine and replace any broken parts

immediately.

„

aLWayS store equipment properly when it is not being

used. Equipment should be stored in a clean, dry location

out of the reach of children and unauthorized personnel.

„

A safety manual for operating and maintenance

personnel of concrete power trowels produced by the

Association of Equipment Manufacturers (AEM) can be

obtained for a fee by ordering through their website at

www.aem.org.

Order FORM PT-160

eNgINe SaFeTy

WaRNINg

„

DO NOT place hands or fingers inside engine

compartment when engine is running.

„

NeveR operate the engine with heat shields or

guards removed.

„

Keep fi ngers, hands hair and clothing away

from all moving parts to prevent injury.

„

DO NOT remove the radiator cap while the

engine is hot. High pressure boiling water will gush out

of the radiator and severely scald any persons in the

general area of the trowel.

„

DO NOT remove the coolant drain plug

while the engine is hot. Hot coolant will

gush out of the coolant tank and severely

scald any persons in the general area of

the trowel.

„

DO NOT remove the engine oil drain plug while the

engine is hot. Hot oil will gush out of the oil tank and

severely scald any persons in the general area of the

trowel.

CauTION

„

NeveR touch the hot exhaust manifold,

muffl er or cylinder. Allow these parts to cool

before servicing equipment.