Multiquip WBH16_16E - Manual (Page 26)

page 26 — WBH16/WBH16e poWer Buggy (S/n 110401 & up) • operaTion and parTSmanual — rev. #0 (06/14/11)
trOuBlesHOOtinG
Troubleshooting (power Buggy)
Symptom possible problem Solution
Loss of Power.
Speed control cable out of adjustment?
Adjust speed control cable. Replace cable if
necessary
Hydraulic oil level low.? Check hydraulic oil level. Add oil if necessary.
Contaminated hydraulic oil fi lter? Replace hydraulic oil fi lter.
Low engine RPM? Check engine speed.
Loss of Travel.
Forward/Reverse lever in neutral position? Place lever in either forward or reverse position.
Check hydraulic motors.
Parking brake partially engaged? Release parking brake.
System Operating Hot.
Hydraulic oil level low?
Check hydraulic oil level add hydraulic oil if
necessary.
Defective cooling fan? Inspect cooling fan, replace if necessary.
Slow Dumping.
Low engine speed?
Check engine speed. Adjust engine speed if
necessar.y
Dump cylinder is internally bypassing oil? Replace dump cylinder.
System jerky when started.
Speed cable out of adjustment? Adjust speed control cable.
Defective drive motors? Check drive motors, replace if necessary.
Diffi cult to steer. Un-lubricated steering column? Lubricate steering column.
Parking brake will not hold. Brake linkage out of adjustment? Use smaller diameter hose or replace hose.
Diffi culty in stopping . Brakes out of adjustment? Brake lining worn. Replace brake lining.
Engine will not start.
Low on fuel or fuel tank empty? Add fuel.
Defective kill switch? Check kill switch. Replace if necessary
Engine ON/OFF switch in OFF position? Set engine ON/OFF switch to ON position.
Fuel Shut-off valve CLOSED? Open Fuel shut-off valve.