Multiquip WBH16_16E - Manual (Page 19)

WBH16/WBH16e poWer Buggy (S/n 110401 & up)• operaTion and parTS manual — rev. #0 (06/14/11) — page 19
OperatiOn
eleCTriC STarT (WBH16e only)
1. Before attempting to start the power buggy, make sure
that the safety kill switch (Figure 19) is not pushed
in. The power buggy will not start with the kill switch
engaged.
2. Place the engine fuel lever to the ON position.(Figure 8).
Figure 8. Engine Fuel Lever (ON Position)
3. Place the choke lever (Figure 9) in the CLOSED
position if starting a cold engine.
Figure 9. Engine Choke Lever (Closed)
CauTion
do noT attempt to operate the power
buggy until the Safety Information, General
Information, and Inspection sections of this
manual have been read and thoroughly
understood.
NOTICE
The CLOSED position of the choke lever enriches
the fuel mixture for starting a cold engine. The OPEN
position provides the correct fuel mixture for normal
operation after starting, and for restarting a warm
engine.
4. Place the choke lever (Figure 10) in the OPEN position
if starting a warm engine or the temperature is warm.
Figure 10. Engine Choke Lever (Open)
5. Move the throttle lever halfway between the FAST and
SLOW position (Figure 11) for starting.
Figure 11. Throttle Lever
6. Turn the engine ON/OFF switch (Figure 12 )to the
START position and hold it until the engine starts. When
engine starts, release the key, allowing it to return to
the ON position.
Figure 12. Engine ON/OFF Switch
(Electric Start)
OFF O
N
S
T
A
R
T