Multiquip WBH16_16E - Manual (Page 20)

page 20 — WBH16/WBH16e poWer Buggy (S/n 110401 & up) • operaTion and parTSmanual — rev. #0 (06/14/11)
OperatiOn
7. Make sure the choke lever is in the OPEN position
(Figure 10) before operating the power buggy. Before
the buggy is placed into operation, run the engine for
several minutes. Check for fuel leaks, and noises that
would associate with a loose guard or cover.
reCoil STarT
1. Follow steps 1 through 5 of the Electric Start procedure.
2. Place the Engine ON/OFF switch (Figure 13) in the
ON position.
Figure 13. Engine ON/OFF Switch (Recoil Start)
3. Grasp the starter grip (Figure 14) and slowly pull it
out. The resistance becomes the hardest at a certain
position, corresponding to the compression point. Pull
the starter grip briskly and smoothly for starting.
Figure 14. Starter Grip
4. If the engine has started, slowly push the choke lever
inward to the RUN position. If the engine has not
started, repeat steps 1 through 3.
OR
OFF O
N
S
T
A
R
T
NOTICE
DO NOT pull the starter rope all the way to the end.
DO NOT release the starter rope after pulling. Allow it
to rewind as soon as possible.
pre-CHeCK
1. Engage the parking brake lever (Figure 15) and attempt
to rock the buggy back and forth. If the wheels turn
during the rocking motion, adjust the brakes as outlined
in the maintenance section of this manual.
Figure 15. Parking Brake Lever
2. Place the engine's throttle lever (Figure 11) in the slow
(idle) position.
3. Check the speed control lever (Figure 16) located on
the right side of the handle bar. The speed control
should work freely when squeezed by hand, and return
to the closed position when released.
Figure 16. Speed Control Lever