beautypg.com

Maintenance (mixer) – Multiquip C10PH8 User Manual

Page 26

background image

PAGE 26 — C10SH8-PH8 CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #0 (03/06/09)

Wheel Lug Nuts Tightening

Figure 22.

Sequence

MAINTENANCE (MIXER)

Lug Nut Torque Requirements

It is extremely important to apply and maintain proper wheel
mounting torque on the trailer. Be sure to use only the
fasteners matched to the cone angle of the wheel. Proper
procedure for attachment of the wheels is as follows:

Start all wheel lug nuts by hand.

1.

Torque all lug nuts in sequence. See Figure 22.

2.

DO

NOT torque the wheel lug nuts all the way down.
Tighten each lug nut in 3 separate passes as defi ned
by Table 9.

After fi rst road use, retorque all lug nuts in sequence.

3.

Check all wheel lug nuts periodically.

MIXER STORAGE

For storage of the mixer for over 30 days, the following is
recommended:

Drain the fuel tank completely, or add STA-BIL to the

fuel.

Run the engine until the fuel is completely consumed.

Completely drain used oil from the engine crankcase

and fi ll with fresh clean oil, then follow the procedures
described in the engine manual for engine storage.

Clean the entire mixer and engine compartment.

Place the mixing drum in the down position (mouth facing

downward).

Cover the mixer and place it a clean dry area, that is

protected from harsh elements.

Tire Torque Requirements

Table 9.

Wheel Size

First Pass

FT-LBS

Second Pass

FT-LBS

Third Pass

FT-LBS

12"

20-25

35-40

50-65

13"

20-25

35-40

50-65

14"

20-25

50-60

90-120

15"

20-25

50-60

90-120

16"

20-25

50-60

90-120

This manual is related to the following products: