Multiquip C10PH8 - Manual (Page 20)

PAGE 20 — C10SH8-PH8 CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #0 (03/06/09)
OPERATION
STARTING THE ENGINE
The following steps outline the procedure for starting the
engine. Depending on the type of engine employed in the
mixer, the steps may vary slightly.
Move the fuel shut-off lever (Figure 7) to the ON 1.
position.
Fuel Shut-Off Lever Figure 7.
To start a cold engine, move the choke lever (Figure 2.
8) to the CLOSED position.
Choke Lever Figure 8.
Move the throttle lever (Figure 9) away from the slow 3.
position, about 1/3 of the way toward the fast position.
Throttle Lever Figure 9.
Turn the engine switch (Figure 10) to the ON position. 4.
Engine ON/OFF Switch Figure 10.
Located at the rear of the mixer frame is the main start/ 5.
stop button (Figure 11). Pull this button outward to start
the engine.
Engine Start/Stop Button Figure 11.
Pull the starter grip (Figure 12) lightly until you feel 6.
resistance, then pull briskly. The drum should be
rotating at this time.
Starter Grip Figure 12.