beautypg.com

Inspection/setup – Multiquip GA-6HRS User Manual

Page 23

background image

ga6HR/6HRS 60 hz gENERATOR • OpERATiON ANd pARTs mANuAl — REv. #0 (08/12/14) — pAgE 23

INSPECTION/SETuP

Before starting

1. Read safety instructions at the beginning of manual.
2. Clean the generator, removing dirt and dust, particularly

the engine cooling air inlet, carburetor and air cleaner.

3. Check the air filter for dirt and dust. If air filter is dirty,

replace air filter with a new one as required.

4. Check carburetor for external dirt and dust. Clean with

dry compressed air.

5. Check fastening nuts and bolts for tightness.

BATTERY sETup (gA6hRs)

1. Place the battery into the battery cradle and secured

with mounting hardware.

2. Connect the positive cable to the positive terminal on

the battery first, then connect the negative cable to the

negative terminal.

Engine Oil Check

1. To check the engine oil level, place the generator on

secure level ground with the engine stopped.

2. Remove the filler dipstick from the engine oil filler hole

(Figure 10) and wipe clean.

Figure 10. Engine Oil Dipstick Removal

NOTICE

AlWAYs place the main circuit breaker in the OFF

position prior to starting the engine.

CAuTiON

Use all safety precautions specified by the battery

manufacturer when working with the battery. See Safety

Information section of this manual for more details on

battery safety.

3. Insert and remove the dipstick without screwing it into

the filler neck. Check the oil level shown on the dipstick.

4. If the oil level is low (Figure 11), fill to the edge of the

oil filler hole with the recommended oil type (Table 5).

Maximum oil capacity is 1.16 quarts (1.1 liters).

Figure 11. Engine Oil Dipstick(Oil Level)

Table 5. Oil Type

season

Temperature

Oil Type

Summer

25°C or Higher

SAE 10W-30

Spring/Fall

25°C~10°C

SAE 10W-30/20

Winter

0°C or Lower

SAE 10W-10

Fuel Check

1. Close the fuel cock before filling the fuel tank.
2. Remove the fuel cap located on top of fuel tank.
3. Read the fuel gauge located on top of the fuel tank

(Figure 12) to determine if the fuel level is low. If fuel

is low, replenish with clean unleaded fuel.

Figure 12. Fuel Gauge

4. When refueling, be sure to use a strainer for filtration.

dO NOT top-off fuel. dO NOT fill the tank beyond

capacity. Wipe up any spilled fuel

immediately!

This manual is related to the following products: