Daw-500s — engine operating instructions – Multiquip DAW500S User Manual

Page 31

DAW-500S WELDER/A.C. GENERATOR — PARTS & OPERATION MANUAL — REV.#0 (07/19/01) — PAGE 31

7. When the engine starts, the oil pressure light and charge

light should go out. If these lights stay on, immediately
stop the engine and check the system and wiring (refer to
the Kubota Engine Operator's Manual).

8. Let the engine idle for five minutes with the automatic idle

control switch in the “ON” position.

9. Check the engine for abnormal vibrations, noises and oil

leakage.

10. Check the generator's output voltage by referring to the

DC voltmeter on the control panel.

Shutdown

1. Remove the load from the welder/AC generator, then

place both the main and GFCI circuit breakers to the
"OFF" position.

2. Listen for the engine speed to drop. Run at low speed

for 3-5 minutes.

3. Stop the engine by turning the key to “STOP” position

and remove the key. Turn the fuel cock lever to the
“OFF” position.

DAW-500S — ENGINE OPERATING INSTRUCTIONS