Multiquip QP204H - Manual (Page 9)

QP-204H CENTRIFUGAL PUMP — OPERATION AND PARTS MANUAL— REV. #3 (06/05/06) — PAGE 9
QP-204H — RULES FOR SAFE OPERATION
Maintenance Safety:
■ NEVER lubricate components or attempt service on a
running machine.
■ ALWAYS allow the machine a proper amount of time to
cool before servicing.
■ Keep the machinery in proper running condition.
■ Fix damage to the machine immediately and always replace
broken parts.
■ Dispose of hazardous waste properly. Examples of
potentially hazardous waste are used motor oil, fuel and
fuel filters.
■ DO NOT use food or plastic containers to dispose of
hazardous waste.
■ DO NOT pour waste, oil or fuel directly onto the ground,
down a drain or into any water source.
EMERGENCIES
■ ALWAYS know the location of the
nearest fire extinguisher .
■ ALWAYS know the location of the nearest
first aid kit .
■ In emergencies always
know the location of the
nearest phone or keep a phone on the job site .
Also know the phone numbers of the nearest
ambulance , doctor and fire department . This
information will be invaluable in case of an
emergency.
■ NEVER run engine without air cleaner. Severe engine damage
may occur.
■ ALWAYS read, understand, and follow procedures in
Operator’s Manual before attempting to operate equipment.
■ ALWAYS be sure the operator is familiar with proper safety
precautions and operation techniques before using pump.
■ ALWAYS store equipment properly when it is not being used.
Equipment should be stored in a clean, dry location out of the
reach of children.
■ NEVER leave the pump unattended, turn off engine when
unattended.
■ Unauthorized equipment modifications will void all
warranties.
■ NEVER pump volatile, explosive, flammable or low flash
point fluids. These fluids could ignite or explode.
■ NEVER operate the pump in an
explosive atmosphere.
■ Before starting the pump, check that the clean-out cover is
securely fasten.
■ ALWAYS ensure pump is on level ground before use.
■ Become familiar with the components of the pump before
operating.
■ ALWAYS replace any worn or damaged warning decals.
■ NEVER pump corrosive chemicals or water containing toxic
substances. These fluids could create serious health and
environmental hazards. Contact local authorities for
assistance.
■ NEVER open the priming plug when
pump is hot. Hot water inside could be
pressurized much like the radiator of an
automobile. Allow pump to cool to the
touch before loosening plug.
The
possibility exists of scalding, resulting
in severe bodily harm.
■ NEVER disconnect any "emergency or safety devices".
These devices are intended for operator safety. Disconnection
of these devices can cause severe injury, bodily harm or even
death! Disconnection of any of these devices will void all
warranties.
TRANSPORTING
■ ALWAYS shutdown engine before transporting.
■ Tighten fuel tank cap securely and close fuel cock to prevent
fuel from spilling.
■ Drain fuel when transporting pump over long distances or
bad roads.
■ ALWAYS tie down the pump during transportation by securing
the pump's guard frame with rope.
■ NEVER open the pump housing during operation or start the
pump with the clean-out cover removed. The rotating impeller
inside the pump can cut or sever objects caught in it.
■ NEVER block or restrict flow from discharge hose. Remove
kinks from discharge line before starting pump. Operation
with a blocked discharge line can cause water inside pump
to overheat.
■ ALWAYS fill the pump casing with water before starting the
engine. Failure to maintain water inside the pump housing
will cause severe damage to the pump.
■ In winter drain water from pump housing to prevent freezing.