Multiquip QP204H - Manual (Page 18)

PAGE 18 — QP-204H CENTRIFUGAL PUMP — OPERATION AND PARTS MANUAL — REV. #3 (06/05/06)
QP-204H — INITIAL START-UP (ENGINE)
Starting the Engine ( HONDA engine)
1. Place the engine fuel valve lever (Figure 7) to the "ON"
position.
2. Move the throttle lever (Figure 8) away from the slow
position, about 1/3 of the way toward the fast position.
Figure 7. Engine Fuel Valve Lever (ON Position)
Figure 8. Throttle Lever (1/3 Start Position)
3. Place the choke lever (Figure 9) in the " CLOSED " position
if starting a cold engine.
4. Place the choke lever (Figure 10) in the " OPEN " position
if starting a warm engine or the temperature is warm.
Figure 10. Engine Choke Lever (Open)
Figure 9. Engine Choke Lever (Closed)
5. Place the engine ON/OFF switch (Figure 11) in the " ON "
position.
Figure 11. Engine ON/OFF Switch (ON Position)
This section is intended to assist the operator with the initial
start-up of the trash pump. It is extremely important that this
section be read carefully before attempting to use the pump in
the field.
DO NOT attempt to operate the pump until
the Safety, General Information and
Inspection sections of this manual have
been
read and thoroughly understood .
CAUTION - Read Manual