Multiquip P33/24 HHMR - Manual (Page 23)

23 23
Operation:
5.0 Operation with remote control
5.1 Precommissioning checks
Before putting the machine into service every day or before a long work period, the following checks must be
performed.
i Danger
Observe the safety remarks in section 3.0 of this operating and maintenance manual.
• Place the machine on an even, load-bearing surface.
Check:
• All
screw joints
• Function of the travel levers
• Function of the back-up safety bar
• The machine for any damage
• The emergency stop switch of the transmitter
Remark:
The following checks are described in the section „9.0 Maintenance“!
• Engine oil level
• Hydraulic oil level
• Fuel level
5.2 Operation
When operating the machine with remote control, the correct position is behind the roller. Zone „A“. If the operator is
standing on the other side - Zone „B“ - the actuating directions of the control elements do
not correspond to those of the roller.
Zone B Zone A
When operating the machine with the remote control, the minimum distance from the machine must be 2 metres, as
under some operating conditions refl ections occur which can cause errors in the close range
stop function.