Multiquip MRH800GS - Manual (Page 24)

PAGE 24 — MQ-MIKASA MRH800GS ROLLER — OPERATION AND PARTS MANUAL — REV. #5 (05/27/08)
STARTING THE ENGINE
The engine can be started by motor (electric) or manually
(recoil). Refer to Figures 3 and 4 for the location of
controls and components.
MRH800GS — OPERATION
Figure 13. Engine Fuel Valve Lever (ON Position)
3. Place the choke lever (Figure 14) in the " OPEN " position
if starting a cold engine.
4. Place the choke lever (Figure 15) in the " CLOSED " position
if starting a warm engine or the temperature is warm.
Figure 14. Engine Choke Lever (Open)
Figure 15. Engine Choke Lever (Closed)
5. Place the engine ON/OFF switch (Figure 16) in the " ON "
position.
Figure 16. Engine ON/OFF Switch (ON Position)
7. If the engine has started, slowly return the choke lever
(Figure 17 ) to the CLOSED position. If the engine has not
started repeat steps 1 through 6.
8. Before the roller is placed into operation, run the engine for
several minutes. Check for fuel leaks, and noises that would
be associated with a loose component.
Figure 17. Choke Lever (Closed)
Make sure to follow all safety rules referenced in
the safety section of this manual before operating
roller. Keep work area clear of debris and other
objects that could cause damage to the roller or
bodily injury.
CAUTION :
Electric Start
1. On the control handle:
A. Move the throttle lever to the RUN position.
B. Move the travel lever to the NEUTRAL position.
C. Move the vibration lever to the OFF position.
2. Place the engine fuel valve lever (Figure 13) to the "ON"
position.
When the engine is running, NEVER turn the
starter key to the START position
CAUTION :