Multiquip MRH800GS - Manual (Page 17)

MQ-MIKASA MRH800GS ROLLER — OPERATION AND PARTS MANUAL — REV. #5 (05/27/08) — PAGE 17
MRH800GS — VIBRATION ROLLER COMPONENTS
Figure 3 illustrates the location of the major components
for the MRH800GS Vibration Roller. The function of each
component is described below:
1. Fuel Tank/Cap – Fill with diesel fuel. Fuel tank holds
approximately 2 gallons (7.5 liters). DO NOT top off fuel.
Wipe up any spilled fuel immediately.
2. Hydraulic Oil Tank - Fill with proper grade of hydraulic oil.
Check fluid level using the hydraulic oil gauge.
3. Front Headlights – Activate using switch on control
handle. Use to illuminate ground durring nighttime or low
light operating conditions.
4. Vibration Rollers – 25-inch wide steel drums that provide
compaction force in the compaction and patching of asphalt
type surfaces.
6. Center Cover – When opened and supported by strut,
provides access to
oil pump and filter, battery, V-belt, and
clutch box .
6. Water Tank– Holds 10.57 gallons (40 liters) for the sprinkler
system.
7. Lifting Hook – Used to lift the machine with crane or other
lifting device.
8. Hydraulic Oil Gauge – Indicates the hydraulic oil level.
9. Engine – This machine uses the Honda GX390K1SM32
gasoline engine. Refer to page 20 for more information.
10. Parking Brake – Makes sure machine will not accidentally
move when parked or not in use.
11. Vibrator Oil Level Plug – Remove to check vibrator oil
level.