MTS Model 409.83 Temperature Controller - Manual (Page 24)

Model 409.83 Temperature Controller 24
Model 409.83 Temperature Controller Configuration
Installation
Model 409.83 Temperature Controller Configuration
Through the configuration level you can set up the fundamental characteristics of
the controller. These include:
• The type of control
• The input type and range
• The alarm functions
• The output functions
• The communications configuration
• Calibration
• Passwords
Selecting an access
level
1. Access the configuration level.
• If the controller is powered up, select the appropriate configuration
level.
• If the controller is not powered up, press and hold the up and down
arrows simultaneously while powering up the controller. This takes you
directly to the ConF password entry display.
2. At the PASS prompt, enter the configuration password.
The password is initially factory-set to 2.
Note Refer to the Eurotherm Model 2216 Temperature Controller manual for
information on changing passwords.
3. Press the scroll button.
The first display of the configuration will be shown.
A. To return to the operator access level from the ConF access level, press
the page and scroll buttons simultaneously. At the Exit prompt, use the
up or down arrows to select Yes. This will return you to the Home
display in the operator access level.
Configuration is protected by password and should only be carried out by
qualified persons.
Incorrect configuration could result in damage to the process being controlled or
personal injury.
Note For complete information on parameter availability (including navigation
diagrams), refer to the Eurotherm Model 2216 Temperature Controller
manual.
CAUTION