MTS Model 409.83 Temperature Controller - Manual (Page 21)

Model 409.83 Temperature Controller Installation 21
Installation
This chapter provides installation information for the Model 409.83 Temperature
Controller.
Do not use this controller with incompatible furnaces.
The temperature controller is programmed for use with the Model 652 or 653 High
Temperature Furnaces. The heating elements of older furnaces could be
damaged if used with this temperature controller.
Note The 409.83 is a class 1 LED product as defined by the CE low voltage
directive.
Mounting
considerations
The Model 409.83 Temperature Controller can be mounted on a table top (with
an optional table top bracket) or floor stand. The temperature controller must be
mounted such that the lamps on the controller are visible from the furnace.
1. Ensure that the temperature controller has arrived with no shipping damage.
If damaged, contact the Customer Service division of MTS Systems
Corporation.
2. Locate the table-top or floor stand that accompanied the controller. Mount
the temperature controller to it using the nuts and bolts provided.
3. Connect cables and wires per the cable assembly drawing.
AC power disconnect
Turn off the AC power switch. Remove the AC power cord from the unit. This
will remove all AC power from the chassis.
Note Be sure to locate the chassis so that you have adequate access to
disconnect the power cord form the chassis.
CAUTION