MMF POS Standard RS-232 Connection Interface Kit - Manual (Page 5)

531-8661-00 MMF Multi-Serial Interface Page 4 of 12
 Switch 3
“Dumb Mode” any open character based on the number of pulses within that ASCII character will open the cash
drawer.
 The above SW3 Functions only apply when the controller is set to “Dumb Mode” (SW3-1 = OFF)
“Smart Mode” open character and RS-232 settings are pre-selected.
 The above SW3 Functions only apply when the controller is set to "Smart Mode" (SW3-1 = ON)
 Parity / 7 Data Bits Note: When the number of data bits is set to 7 (SW2-8 = OFF) parity must
be Enabled
(SW3-7 = ON). Setting the number of data bits to 7 while parity is disabled will result in an invalid mode. If the
controller is set to this mode, LED #1 (green) and LED #2 (red) will blink to indicate the invalid condition.
P
O
S SW3 - "Dumb Mode"
FUNCTION
1 Smart Mode (ON) / Dumb Mode (OFF) Select
2 Drawer Status Polarity (OFF = Norm / ON = Invert)
3 Pulse Count 0
4 Pulse Count 1
5
Reserved
6 Reserved
7 Reserved
8 Reserved
PULSE COUNT SELECT SW3
Pos 4 Pos 3 Number
P-Cnt 1 P-Cnt 0 of Pulses
OFF ON 4 Pulses
OFF OFF 4 Pulses
ON ON 3 Pulses
ON OFF 2 Pulses
P
O
S SW3 - "Smart Mode"
FUNCTION
2 Drawer Status Polarity (OFF=Norm / ON=Invert)
3 Baud Rate
4 Baud Rate
5 Baud Rate
6 Parity Type (OFF = Even / ON = Odd)
7 Parity Enable (ON = Parity Enabled)
8 Number of Data Bits (OFF = 7 Bits, ON = 8 Bits)
BAUD RATE SELECT
Pos
5
Pos
4
Pos
3 Baud Rate
OFF OFF OFF 300
OFF OFF ON 600
OFF ON OFF 1200
OFF ON ON 2400
ON OFF OFF 4800
ON OFF ON 9600
ON ON OFF 19200