MK Diamond MK-770 Blade Alignment - Manual (Page 5)

45 Cutting Head Tile Saw- Revision 12/00, Effective Date Date December 04, 2000 Page-5
45 CUTTING HEAD TILE SAW-BLADE ALIGNMENT PROCEDURE
45º Alignment Verification:
The 45º Alignment Verification is done to ensure the blade will cut tile at a 45º angle.
NOTES: If the blade is misaligned following this alignment verification procedure, return the saw to MK
Diamond for repair.
The Diamond Blade must be removed and reinstalled when removing the Blade Guard.
(A)
Remove Blade Guard
(If not done Previously)
(B)
Position the Cutting Head
to the 45º Cutting Angle
(C)
Place Square on the Movable
Cutting Table and position the
Square against the Blade
(D)
Verify Blade is even
across all points of Square
(E)
To Adjust 45º Cutting Angle,
locate the 45º
Adjustment Screw
(F)
Rotate 45º Adjustment Screw
clockwise or counter-clockwise
to realign 45º Cutting Angle
(G)
Verify Blade is now even
across all points of Square
(H)
Repeat steps A to G until Blade is
even across all points of
Square
Blade Guard Rotate Counter-
clockwise to Loosen
Blade Guard
Retaining Nut
Rotate Counter-
clockwise to Loosen
Diamond Blade Square
Movable Cutting Table
No Gaps between
Blade and Square Rotate to Adjust
Vertical Alignment
45º Adjustment
Screw (Upper Screw)
No Gaps between
Blade and Square Repeat