MK Diamond MK-770 Blade Alignment - Manual (Page 3)

45 Cutting Head Tile Saw- Revision 12/00, Effective Date Date December 04, 2000 Page-3
45 CUTTING HEAD TILE SAW-BLADE ALIGNMENT PROCEDURE
Alignment Screw, 90º Verification:
90º-alignment verification will ensure that the blade will cut the tile straight up and down and not at an angle.
NOTES: If the blade is misaligned following this alignment procedure, return the saw to MK Diamond for repair.
The Diamond Blade must be removed and reinstalled when removing the Blade Guard.
(A)
Position the Cutting Head
to the 45º Cutting Angle
(B)
Locate the 90º
Adjustment Screw
(C)
Rotate 90º Adjustment Screw
clockwise or counter-clockwise
to realign Cutting Head
(D)
Position the Square on
Movable Cutting Table
against the Diamond Blade
(E)
Verify the Diamond Blade
is Square to the Movable
Cutting Table
(F)
Repeat Steps A to E as
necessary to align the
Cutting Head
Repeat
90º Adjustment
Screw (Lower Screw)
Rotate Counter-
clockwise to Loosen
Diamond Blade Square No Gaps between
Blade and Square
Rotate to Adjust
Vertical Alignment
Movable Cutting Table