MK Diamond MK-770 Blade Alignment - Manual (Page 2)

45 Cutting Head Tile Saw- Revision 12/00, Effective Date Date December 04, 2000 Page-2
45 CUTTING HEAD TILE SAW-BLADE ALIGNMENT PROCEDURE
Movable Cutting Table Alignment Verification:
This will verify the Movable Cutting Table is aligned to the frame of the saw.
NOTES: If the blade is misaligned following alignment verification, attempt to align using Alignment Screw, 90º
Verification.
The Diamond Blade must be removed and reinstalled when removing the Blade Guard.
(G)
Move Wheel Assembly up or
down to Square the Movable
Cutting Table
(A)
Remove Blade Guard
(I)
Tighten Movable Cutting Table
Wheel Assembly
Wheel Assembly
Retaining Bolts
Direction of
Movement
Wheel
Assembly
Wheel Assembly
Retaining Bolts
1/2-inch
Wrench
Rotate Counter-
clockwise to Loosen
1/2-inch
Wrench
(F)
If Gap exists, loosen Movable
Cutting Table Wheel Assembly
Blade Guard
Retaining Nut
(B)
Guide Bar side of Movable
Cutting Table, Height
Determination Setup
Place Straight-
edge on Frame
(C)
Guide Bar side of Movable
Cutting Table, Height
Determination
Adjust Square
until Resting on
Straightedge
Lock in
Position
(D)
Wheel Assembly side of
Movable Cutting Table,
Height Determination Setup
Place Straight-
edge on Frame
(E)
Verify Wheel Assembly side of
Movable Cutting Table height
is same as Guide Bar side
Check for Gap
Between Square
and Straightedge
Straightedge
Square
(H)
Re-Verify Wheel Assembly side of
Movable Cutting Table height
is same as Guide Bar side
Check for No Gap
Between Square
and Straightedge
Straightedge
Square
Place Square
on Cutting Table
Blade Guard
Place Square
on Cutting Table
Rotate Counter-
clockwise to Loosen
Rotate Clockwise
to Tighten