MK Diamond MK-770 Blade Alignment - Manual (Page 4)

45 Cutting Head Tile Saw- Revision 12/00, Effective Date Date December 04, 2000 Page-4
45 CUTTING HEAD TILE SAW-BLADE ALIGNMENT PROCEDURE
Horizontal Rough Alignment:
The Horizontal alignment will ensure that straight cuts (or Rip Cuts) are made.
Horizontal Final Alignment:
Horizontal Alignment Verification:
(C)
Move the Cutting Table back and
forth to re-verify Blade is even
across all points of Square
(E)
Position end of Square
against Blade
End of Square Blade
(A)
Pull Movable Cutting Table
to front of Tile Saw
(B)
Position Square flat on Movable
Cutting Table against Ruler/Stop
(C)
Position front of Square
against Blade
(C)
Move Guide Rail until Blade
centered in Cutting Groove
(A)
Move the Cutting Table back and
forth to verify Blade is even
across all points of Square
(B)
Tighten Guide Bar
Retaining Bolts
(B)
Loosen front and rear
Guide Bar Retaining Bolts
Center Blade
In Cutting Groove
Ruler/Stop
End of Square
Flush with Blade
Front of
Square
Set Square Off
Blade
Move Cutting
Table
Turn Clockwise
to Tighten
Re-verify Gap
Even Along
Length of Square
Turn Counter-
clockwise
to Loosen
Position Movable
Cutting Table to Front
(D)
Move Guide Bar using Adjusting
Bracket until Square rests evenly
across Blade
(F)
Move Guide Bar using Adjusting
Bracket until Square rests evenly
across Blade
End of Square
Flush with Blade
Guide Bar
Open End Wrench
Adjusting Bracket
Open End
Wrench
Guide Bar
(A)
Position Cutting Head
to normal Cut Depth
Adjust Cutting
Head to Cut Depth
of Approx _”
1/4-inch
Wrench
Rotate Clockwise or
Counterclockwise
to Adjust Height
Place Square
Against
Ruler/Stop
Verify Gap Even
Along Length
of Square
Set Square Off
Blade
Move Cutting
Table
Blade