MK Diamond MK-EZ Profile Milling Machine - Manual (Page 17)

17
Follow the assembly instructions to prepare your MK-EZ Profiler for operation.
PUMP INSTALLATION
CUTTING HEAD INSTALLATION
(B)
Remove the Frame Assembly
from the pan, setting it next to
the pan.
(E)
Place the Frame assembly back in the pan
ensuring that the water hose is not pinched,
and pump cord comes out of the pan at
the back of the unit, where it can easily be
plugged into the pump attachment plug on the
motor (once the cutting head is installed).
(A)
Remove base (with suction
cups) from water pump (if
included). Pull off front cover,
slide base off of pump, and
replace the cover.
(D)
Place pump in pan.
(A)
Remove the two bolts and
washers at the back of the
cutting head mount.
(B)
Place the cutting head in position
and replace the bolts and washers,
through the vertical slots in the
cutting head slide.
(C)
Slide the head down, until the end
of the vertical adjustment screw
is sitting in the hole in the cutting
head mount.
(C)
Attach the loose end of the
water hose (that is attached to
the water nozzle) to the pump.
MK-EZ PROFILER INSTALLATION