Metal Sales Metal Roofing and Siding - Manual (Page 16)

Application Manual 30 Effective Date 12/08 31
c
ondition
d
etAilS
(
cont
.)
Wall Panel/Siding
Roofing Nail or Flat Head Screw
Panel Fastener
Inside Closure
Tape Sealant*
Endwall Flashing
Roofing Panel
30# Roofing Felt
*Tape Sealant
Outside Closure
Stitch Screw (at each rib)
Notes:
W-Valley, Gable, Hip, Sidewall, Prow, Jamb,
and Corner trims should all be started at
the bottom of the roof or wall with the next
(upper) trim overlapping the lower trim.
All trims should be lapped a minimum of
3” with a continuous bead of sealant
between trims. Then attach the trims
with a pop rivet or stitch screw.
Wall Panel/Siding
Nail or Flat Head Screw
Panel Screw
Inside Closure
Tape Sealant
Moisture Barrier
Sidewall Flashing
30# Roofing Felt
Roof Panel
Stitch Screw (1'-0")
Stitch Screw (one per rib)
Hip/Valley Closure
Panel Screw
Roof Panel
Universal Ridge
Cut roofing panels to match the angle of the hip. Be sure
to file/remove all metal shavidngs and burrs off the panels.
Then clear them off the roof. Failure to do so can cause
rust spots which could create serious problems with the
roof. If you need to install a vented hip, follow the “Vented
Ridge Detail” with the exception of cutting the panels to
match the angle of the hip and would require the use of
Hip and Valley Closure rather than the formed closure.
c
ondition
d
etAilS
(
cont
.)
*Tape Sealant at top and bottom of closure
e
ndWAll
d
etAil
S
ideWAll
d
etAil
h
ip
d
etAil