Memmert CDP 115 Peltier cooling unit (Generation 2003) - Manual (Page 9)

9
Waterbath cooling unit CDP 115
The following overview illustrates which of these accessories you require for which installation
option:
Waterbath
model
Lid design
of waterbath
Required accessories (see Table 1) for ...
... Assembly on water-
bath (see Fig. 3)
... Standalone unit
(see Fig. 4)
W..7
flat not possible A
sloping A D G –
W..10
flat not possible A
sloping A D H –
W..14/22
flat not possible B
sloping B D I –
W..29/45
flat not possible C
sloping C E J –
Table 2 Overview of required accessories
3.3 Attachment on waterbath
(only for waterbaths with gable lid)
3.3.1 Replacing lid of waterbath
In order for the cooling unit to be attached to the waterbath, the standard lid must be re-
placed with a special lid (G/H/I/J) (see Table 1 and Fig. 5).
1. Remove the supplied closing panels and
fixture material (I1/I2/J1/J2) from the
special lid I/J (only for special lids for
waterbaths W..14/22/29/45).
If the waterbath is to be operated
without a shaking device: Attach the
closing panel I1/J1 with two supplied
screws on the inside of the lid (Fig. 6).
(This is to prevent heat loss through the
side cut-out in the lid for the shaking
device.)
I1/J1
I/J
Fig. 6
Addition of closing panel when operating the
waterbath without shaker device