Memmert CDP 115 Peltier cooling unit (Generation 2003) - Manual (Page 3)

3
Waterbath cooling unit CDP 115
About this manual
Purpose and target group
This manual describes the construction, function, assembly and operation of CDP 115 Peltier
cooling units for MEMMERT waterbaths. It is intended for use by trained personnel of the
operator, who have the task of assembling and/or operating the unit.
If you as the operator are asked to work on the unit, you should read this manual carefully
before starting work on the unit. Familiarise yourself with the safety regulations. Only perform
the work that is described in this manual. If there is something you don't understand, or
certain information is missing, ask your superior or get in touch with the manufacturer. Do not
do anything without authorisation.
This manual cannot describe all the possible combinations of setup and connection
variations. To make matters clearer, the assembly of two representative waterbaths is
described; the depictions may therefore differ slightly from the actual appearance. But
the assembly always follows the same pattern.
Other documents that you must read:
You should also consult the instruction manual for the waterbath on which the cooling unit is
to be operated.
Storage and Forwarding
This instruction manual belongs with the unit and should always be stored so that persons
working on the unit have access to it. It is the responsibility of the operator to ensure that
persons who work on or who will work on the unit are informed as to the whereabouts of
this instruction manual. We recommend that it is always stored in a protected location close
to the cooling unit. Make sure that the instruction manual is not damaged by heat or damp.
If the cooling unit or the waterbath is sold or transported and then set up again at a different
location, this instruction manual must also go with it.