Memmert CDP 115 Peltier cooling unit (Generation 2003) - Manual (Page 7)

7
Waterbath cooling unit CDP 115
2.4 Intended use
The waterbath cooling unit CDP 115 may only be operated in conjunction with Memmert wa-
terbaths of types W..7, W..10, W..14, W..22, W..29 and W..45. You can determine which type
of waterbath you have from the nameplate on the waterbath.
The waterbath cooling unit CDP 115 may only be used for pumping and cooling water, and
may not be used with other liquids.
3. Assembly and connection
The operating location of the waterbath cooling unit should be chosen so that the fan
opening of the Peltier cooling element (see Fig. 1) remains as free as possible to achieve
the maximum cooling performance. The other two fan openings in the housing must
also remain uncovered.
3.1 Installation options
The waterbath cooling unit CDP 115 can be installed in two ways; it can be
► attached to the waterbath (only for waterbaths with gable lids, Fig. 3;
assembly description from page 9)
► set up separately next to the waterbath (Fig. 4; assembly description from page 14).
Fig. 3 Cooling unit is fixed to the rear of
the waterbath
Fig. 4 Cooling unit standing next to the
waterbath
3.2 Required accessories
Various accessories are required to connect and assemble the waterbath cooling unit CDP 115.
What these are depends on the one hand on the installation method planned (fitted onto the
waterbath or separately, see Fig. 3 and Fig. 4) and on the other, on the waterbath type for
which the cooling unit is to be operated. (You can determine which type of waterbath you
have from its nameplate.)
All accessories are contained in a fixtures and connections set (not part of the delivery, see
Table 1). If you want to assemble the cooling unit on waterbaths with a gable lid, you will also
require a special lid with notches for the cooling tubes.
The following is an overview of the accessories available.