Memmert AtmoCONTROL FDA Version 2.X.X - Manual (Page 13)

D30396 | Date 09/2014 13
AtmoCONTROL FDA Version
4.2.3 Status bar
The status bar gives an overview of the appliances logged on to AtmoCONTROL. Appliances
can be added and removed again.
If the appliance is connected to the computer via Ethernet and it has already been logged
on once, it is automatically recognised and the current operating state (temperature,
alarms) is displayed (Fig. 1).
UF 260plus Laboratory
180
.0°C
i
3 4
1 2
Fig. 1
An appliance of type UF 260 PLUS (1), named "Laboratory" (2) by the user, is registered via Ether-
net (3) in AtmoCONTROL; current temperature 180.0 °C (4)
4.3 Installing the device licence
With AtmoCONTROL FDA, only Memmert appliances with the corresponding electronic licence
provided by Memmert as a file can be programmed and used for the creation of protocols.
Each device controlled with AtmoCONTROL FDA has to have its own licence. Each licence is
device-specific and non-transferable.
There are two methods of installing a licence:
4.3.1 Using a USB storage medium (only possible for PLUS appliances)
1. Switch off the respective appliance.
2. Connect the USB storage medium with the cor-
responding licence.
3. Switch the appliance back on. The licence is
installed automatically. The appliance can now
be registered in AtmoCONTROL as described in
chapter 4.4.