Thermo-hygrometer sensor ts34c-m – Meade Instruments TE923W-M User Manual
Page 9
9
A.LED INDICATOR
• Flashes once when the remote sensor transmits a reading to the main unit.
• Flashes twice when battery power is low.
B. BATTERY COMPARTMENT
Holds two AA-size batteries
C.RESET
Resets all readings
(requires small paper clip.)
D.CHANNEL SWITCH
Selects the desired channel from 1 to 5
E. WALL-MOUNT RECESSED OPENING
Keeps the remote sensor on the wall
Note: Install the batteries and select the channel before mounting the sensor.
Battery installation
• Remove the screws from the battery compartment with a small Phillips screwdriver.
• Set the channel 1 through 5. The switch is located in the battery compartment. Channel 1 is
typically selected if only one remote sensor is being used.
• Install 2 “AA” size alkaline batteries (not included) matching the polarities shown in the battery
battery compartment.
• Replace the battery compartment door and secure the screws.
• Secure the
thermo-hygrometer
remote sensor in the desired location.
Mounting
•
The remote thermo-hygrometer sensor can be placed on the flat surface or mounted on the wall
in vertical position
•
Use the wall mount hardware and screws provided when mounting the thermo-hygrometer
sensor on the wall
Placement tips:
•
The remote thermo-hygrometer sensor should be placed in the area with a free air circulation
and sheltered from the direct sunlight and an extreme weather conditions.
•
Ideally, place the thermo-hygrometer sensor above the natural surfaces (such as a grassy lawn).
•
Avoid placing the thermo-hygrometer sensor near sources of heat such as chimneys and heating
elements.
•
Avoid any areas collecting and radiating a heat from the sun, such as metal, brick or concrete
structures, paving, patios and decks.
• The international standard for the valid air temperature measurements is 4 feet (1.25meters)
above the ground.
Thermo-Hygrometer Sensor TS34C-M
FEATURES
• Remote data transmission to the main unit via 433 MHz signal
• 328 feet (100 meters) transmission range without interference
• LCD display of measured temperature and humidity
• Five (5) transmission channels selection
• Case can be wall mounted using built-in hanger
M
P
4
2
:
5
,
8
0
/
1
1
/
4
d
m
p
.
R
L
L
E
W
Y
E
N
O
H
)
G
N
E
(
1
M
I
W
3
2
9
E
T
9