Meade Instruments TE923W-M - Manual (Page 8)

8
Assembly
• Snap the U-shaped sensor holder onto the UV sensor unit side grooves
• Insert the round end of the U-shaped holder into one of the mounting hardware pieces provided
Battery installation
• Unscrew the lid on top of the UV sensor unit.
• Remove the screw from the battery compartment door with a small Phillips screwdriver
• Insert two 2 “AA” size 1.5V batteries (not included) matching the polarities shown in the
battery compartment.
• Replace the battery compartment door and secure the screw
• Screw the UV sensor unit lid back
Mounting
There are three different options available for mounting the UV sensor: ground stand, stake and
wall mount.
Ground:
• Insert the U-shaped sensor holder round end into the
circular ground stand opening, matching 2 round holes
in the opening
• Secure the sensor in a location with a maximum sun
exposure throughout the day.
Stake:
• Snap the sharp stake end onto the metal bar and secure
with the screws provided.
• Insert the other end of the metal bar into the U-shaped
sensor holder and secure with the screws provided.
• Secure the sensor in a location with a maximum sun
exposure throughout the day.
Wall:
• Insert the wall mounting end into the metal bar
and secure with the screws provided.
• Snap the other end of the metal bar on to the
U-shaped sens or holder and secure with the
screwsprovided.
• Secure the sensor in a location with a maximum
sun exposure throughout the day.
Placement tips:
The UV sensor should be mounted in the area free of sunlight shadows or reflections from the
nearby objects.
Ground
Stake
Wall
TE923W IM1(ENG) HONEYWELL R.pmd 4/11/08, 5:24 PM 8