Meade Instruments TE923W-M - Manual (Page 27)

27
Enabling or Disabling the Time Alarms
• Press the ALARM/CHART to display the Weekday Alarm or Ice Warning Alarm (Pre-Alarm)
time. If these alarms are not set, the abbreviation OFF will be displayed.
• To enable or disable any of these alarms, press UP or DOWN.
Note: Press SET anytime during alarm selection mode to return to the default clock display.
Programming Time Alarms
• In the Clock and Alarm Mode, press the ALARM/CHART selecting the desired alarm.
• Press and hold ALARM/CHART button until the hour digit will flash
• Set the alarm hour using UP or DOWN. Press and hold either button for quick digit advance.
• Press ALARM/CHART to confirm selection.
• Set the alarm minutes using UP or DOWN. Press and hold either button for quick digit advance.
• Press ALARM/CHART to confirm selection.
• Set a Snooze interval (all three alarms share same snooze time duration) using UP or DOWN.
Press and hold either button for quick digit advance.
• Press ALARM/CHART to confirm your selection.
After programming is completed, the display will return to the alarm selection screen.
Disabling or Enabling Snooze function
To enable a snooze function press LIGHT/SNOOZE button.
Note: Alarm will automatically enter the snooze mode if no buttons are pressed after the alarm
sounds for 2 minutes. This will occur for a maximum of three times.
To disable alarm(s):
Press ALARM/CHART to disable the alarm (s).
Note: For weekday alarm, pressing ALARM/CHART will only disable the alarm for the current
day. The alarm will activate again on the next day, Monday through Friday.
TE923W IM1(ENG) HONEYWELL R.pmd 4/11/08, 5:28 PM 27