Marshalltown FCS86 SURFACE SHARK Floor Stripper - Manual (Page 31)

FCS86 SuRFACE ShARK™ FLooR STRIPPER PAgE 31
STORAGE
Proper procedure for long term storage of the
Floor Stripper will protect it against the effects of
corrosion and damage. If the Floor Stripper is not
to be operated for a period of 30 days or more,
proceed to store as follows:
1) Never store the Floor Stripper with the blade
installed. Remove the blade from the Floor Stripper per
the procedures outlined in this manual.
Do not store the Floor Stripper with the
b l a d e a t t a c h e d . T h i s
c o n f i g u r a t i o n c a n r e s u l t i n
property damage and/or personal injury.
2) Clean all accumulated foreign material from the
Floor Stripper utilizing an appropriate safety solvent.
Observe all applicable safety precautions for
the solvent.
3) Check all visible parts for wear, breakage or damage.
order any part required to make the necessary repair.
This will avoid a needless delay when operating the
Floor Stripper at next use.
4) Apply a dry film lubricant to all exposed metal
components to prevent rust.
5) block the bottom of the main frame to prevent
machine weight against the exciter plate. This
procedure will reduce impact loads to the elastomeric
rubber mounts, minimize deflection and increase
service life.
6) Store the Floor Stripper inside. If the Floor Stripper
must be stored outside, protect it with a suitable
covering.
SPECIFICATIONS
FRAME
STRuCTuRE unitized, welded steel plate
DRIvE SySTEM Random orbit, direct shaft mount
NuMbER oF ELASToMERIC RubbER MouNTS 4
WIDTh 14-1/2 inches (368 mm)
WIDTh (AT oPERAToR hANDLE) 23 inches
(584 mm)
LENgTh (hANDLE FoLDED) 24 inches (610 mm)
LENgTh (oPERATINg CoNFIguRATIoN) 34 inches
(864 mm)
hEIghT (hANDLE FoLDED) 23 inches (584 mm)
hEIghT (MAX hANDLE EXTENSIoN) 42 inches
(1067 mm)
GENERAL
WEIghT (WITh EXTERNAL WEIghT 130 lbs
LESS bLADE) (59 kg)
EXTERNAL WEIghT, EACh 14 lbs (6 kg)
ELECTRIC MoToR 3/4 hp, 1725 RPM, 10.3 full
loaded amperes @ 115 vAC, 60 hz, thermally
protected. The electric motor requires a clean (no
other electric products on the same circuit) 15 ampere
capacity circuit to properly function. The motor can be
wired to also operate from a 230 vAC, 60 hz, power
source. Contact the Customer Service Department for
specific information.
NuMbER oF bLADE oSCILLATIoNS 1725
PER MINuTE