Marshalltown FCS86 SURFACE SHARK Floor Stripper - Manual (Page 19)

FCS86 SuRFACE ShARK™ FLooR STRIPPER PAgE 19
FIguRE 16
FIguRE 17
EXERCISE EXTREME CAUTION WHEN
UTILIZING A MECHANICAL DEVICE FOR
LIFTING THE FLOOR STRIPPER. UTILIZE THE
MECHANICAL DEVICE IN ACCORDANCE TO
BOTH ITS DESIGNED STATIC AND DYNAMIC
LOADING ENVELOPES. DO NOT UTILIZE
THE MECHANICAL DEVICE UNTIL THIS
INFORMATION IS PROPERLY KNOWN AND
U N D E R S T O O D B Y A L L A P P L I C A B L E
PERSONNEL. FAILURE TO PROPERLY
UTILIZE THE MECHANICAL DEVICE CAN
RESULT IN PROPERTY DAMAGE AND/OR
PERSONAL INJURY.
Do not drop the Floor Stripper directly
upon the exciter plate. Direct impact against
the exciter plate can result in damage to
components including the plate, elastomeric
rubber mounts, electric motor shaft,
bearings, etc.
2) To minimize the possibility of damage to the
Floor Stripper, always transport in its normal, upright
position. All equipment must be secured in/on
vehicles with suitable strapping or tie-downs.
Personnel should not be transported in the same
compartment as equipment. Consult applicable oShA
and transportation regulations (local, State and Federal)
for the proper transportation of the Floor Stripper.
3) Do not transport the Floor Stripper with a
blade attached to the main frame in the following
configurations:
a) To and from the job site.
b) For longer distances while being repositioned on
the job site.
c) When traversing up and down stairways.
d) While performing maintenance and/or repairs.
e) Lifting up/into or/down from a transporting vehicle.
Remove the blade according to the procedures
as outlined in this manual for the above listed
configurations.
LIFTING, LOWERING AND TRANSPORTING
THE FLOOR STRIPPER WITH A BLADE
INSTALLED CAN RESULT IN PROPERTY
DAMAGE AND/OR PERSONAL INJURY.
4) When transporting to and from the job site, block
the bottom of the main frame to prevent direct impact
blows against the exciter plate. This procedure will
reduce impact loads directly to the elastomeric rubber
mounts, minimize their deflection and increase service
life.