Marshalltown FCS86 SURFACE SHARK Floor Stripper User Manual
Page 15

FCS86 SuRFACE ShARK™ FLooR STRIPPER
PAgE 15
FIguRE 12
For all blades tighten the button head
cap screws with the T-handled Allen wrench
provided. Do not utilize another wrench type
and/or configuration. The T-handled Allen
wrench was chosen to place body parts a
practical distance from the blade during the
fastener tightening and loosening process.
Do not apply excessive impact force to the
button head cap screws. Ample seating
torque can be applied by the T-handled
Allen wrench and normal arm strength levels.
Excessive impact force can cause the T-
handled Allen wrench to slip out of the
button head cap screw, resulting in property
damage and/or personal injury.
Do not substitute a different fastener type
for the button head cap screw configuration.
The button head configuration was chosen
for operational considerations. The use of
other fastener types can increase the
potential for property damage and/or
personal injury.
BLADES ARE EXTREMELY SHARP.
CONTACT WITH THE BLADE CAN RESULT
I N
P R O P E R T Y
D A M A G E
A N D / O R
PERSONAL
INJURY.
BLADES
ARE
PROVIDED WITH A PROTECTIVE COVER
OVER THE CUTTING EDGE. EXERCISE
EXTREME CAUTION WHEN REMOVING
AND/OR REINSTALLING THE PROTECTIVE
COVER. STORE THE BLADE WITH THE
P R O T E C T I V E
C O V E R
P R O P E R L Y
INSTALLED TO MINIMIZE THE POTENTIAL
FOR BLADE DAMAGE AND/OR PERSONAL
INJURY.
7) Return the Floor Stripper to its normal operating
position.
8) Determine that the oN/oFF switch located on the
operator handle is in the oFF position. If the Floor
Stripper is to be used immediately, then reconnect the
extension cord or Floor Stripper to the power source.
UNEXPECTED MACHINE START UP CAN
RESULT IN PROPERTY DAMAGE AND/OR
PERSONAL INJURY.
REMOVING THE BLADE FROM THE FLOOR
STRIPPER
Tools Required: 1 each, 5/32 inch T-handled Allen
wrench provided with the machine.
WHEN INSTALLING OR REMOVING A BLADE
T O / F R O M
T H E
F L O O R
S T R I P P E R ,
A L W A Y S
W E A R
T H E
A P P R O P R I A T E S A F E T Y E Y E W E A R ,
GLOVES, LEATHER SHOES AND LONG
P A N T S
T O
M A X I M I Z E
P E R S O N A L
PROTECTION FROM THE SHARP EDGE(S).
IMPROPER CONTACT WITH A SHARP EDGE
CAN RESULT IN PROPERTY DAMAGE
AND/OR PERSONAL INJURY.
1) Properly disconnect the extension cord or the Floor
Stripper from the power source.
2) To place the operator handle in the work position,
move the handle upright so that the ball-detent pins
can be inserted through the operator handle and main
frame. Determine the ball-detent pins are inserted
through the operator handle and main frame to fully
expose the ball detent. FIguRE 13