Loadstar Sensors DI-100U Digital Load Cell Interface Manual - Manual (Page 6)

DI-100 User's Guide
Page: 6 / 19
P/N : 033-02205-Rev2
1 I
NTRODUCTION
The DI-100 is a 16-Bit Analog-to-Digital Load Cell Interface. It converts millivolt-per-volt rated
output of an analog strain-gauge load cell into a USB digital load cell.
Attach the load cell wiring to the 5-position terminal block, enter the mV/V setting, plug the DI-100
to an available USB port on your PC, and you’ve got a Windows PC friendly weighing module.
Standard Features:
• USB Powered. The DI-100 and the load cell are powered entirely by your PC’s USB port.
• Built-in power conditioning with internally regulated excitation voltage.
• Supports load cells with 300 ohms or greater resistance.
• Supports load cells with up to 3mV-per-Volt rated output.
• Supports 4-wire or 6-wire load cell connections.
• 16-Bit analog-to-digital conversion.
• Calibration data and program parameters are stored permanently on the DI-100.
• Small industrial case with built-in mounting ears.