Lenze Global Drive Control (GDC) - Manual (Page 7)

DMS 1.0 EN - 08/2010
L
7
Control technology | System manual
Safety instructions
2 Safety instructions
Please observe the following safety instructions when you want to commission a controller
or system using the L-force controller.

Read the documentation supplied with the system components thoroughly first
before you start commissioning the devices and the L-force controller!
The system manual contains safety instructions which must be observed!

Danger!
According to our present level of knowledge it is not possible to ensure the
absolute freedom from errors of a software.
If necessary, systems with built-in controllers must be provided with additional
monitoring and protective equipment in accordance with relevant safety
regulations (e.g. law on technical equipment, regulations for the prevention of
accidents), so that an impermissible operating status does not endanger persons
or facilities.
During commissioning persons must keep a safe distance from the motor or the
machine parts driven by the motor. Otherwise there would be a risk of injury by
the moving machine parts.

Stop!
If you change parameters in an engineering tool during there is an online
connection to a device, the changes are directly accepted in the device!
A wrong parameter setting can cause unpredictable motor movements. By an
unintended direction of rotation, too high speed, or jerky operation, the driven
machine parts may be damaged!