Lenze Global Drive Control (GDC) - Manual (Page 15)

1.1 EN - 10/2010
L
15
Global Drive Control | L-force Controller as Gateway
Establishing an online connection
Remedy in the event of an error
 The parameters of the connected drive are read from the connected drive.
5.2 Remedy in the event of an error
 If no drive can be found, the »GDC« displays an error message:
 Proceed as follows to eliminate the error:
– Check the physical connections to the drive controller and the L-force Controller,
– Make sure that the communication parameters set for the physical configuration are
correct.
– Make sure that the device description file for the corresponding device is installed.

Information on the respective target system of the »GDC« can be found in the
corresponding hardware manual.