Lenze EMZ2221IB - Manual (Page 33)

Operation 4
EDKMZ2221IB DE/EN/FR 6.0
33
l
H1_Bedienung−Download
4 Operation
Inserting and removing the memory card

8
Card Module
l
Display is blinking
Anzeige blinkt
E1 Stop drive (T1 for 3s)
E2 Check card
E3 Check drive
E4 Retr
y (T1 or
T2)
E5 Technolog
y drive needed
E6 Drive not supported
E7 Prog. is defect
EF F orma t card (T3)
E1 Antrieb stoppen (T1 für 3s)
E2 Karte prüfen
E3 Antrieb prüfen
E4 Wiederholen (T1 bzw
. T2)
E5 Technologieantrieb nötig
E6 Antrieb nicht unterstützt
E7 Prog.
defekt
EF Karte forma
tieren (T3)
Prog.
Card > Drive
Karte > Antrieb
Prog.
0…9, A…F
Drive > Card Antrieb
> Karte
used
belegt
matched passt
T1
T2
T3
2221
SD-Card
/ Karte
SD
8
Card Module
l
Display is blinking
Anzeige blinkt
E1 Stop drive (T1 for 3s)
E2 Check card
E3 Check drive
E4 Retr
y (T1 or
T2)
E5 Technolog
y drive needed
E6 Drive not supported
E7 Prog. is defect
EF F orma t card (T3)
E1 Antrieb stoppen (T1 für 3s)
E2 Karte prüfen
E3 Antrieb prüfen
E4 Wiederholen (T1 bzw
. T2)
E5 Technologieantrieb nötig
E6 Antrieb nicht unterstützt
E7 Prog.
defekt
EF Karte forma
tieren (T3)
Prog.
Card > Drive
Karte > Antrieb
Prog.
0…9, A…F
Drive > Card Antrieb
> Karte
used
belegt
matched passt
T1
T2
T3
2221
SD-Card
/ Karte

‚
2221_002
)
Note!
ƒ Due to the great variety of memory card types that are available on the
market, we cannot guarantee compatibility. We are not aware of any
restrictions. We recommend the use of SD cards by SanDisk.
If the 7−segment display of the card module shows
0
after the memory
card has been inserted, the memory card has been identified. If an error
(
E...
) is reported, read the chapter "Troubleshooting and fault elimination"
( ^ 38).
ƒ With the Card File Handler software you can manage the data on the
memory card comfortably on the PC. The program and further information
on this topic can be found in the download area at http://www.Lenze.de.