Lenze MCH Series Drives - Manual (Page 9)

RG-MHLON 6
Drive Setup & Programming
3 Drive Setup and Programming
Most drive parameters (including those required for serial communications) are not accessible through the
LonWorks® interface. They can only be accessed by entering the Programming Mode of the drive itself.
Refer to the MCH Installation and Operation Manual (MH01) for more information. The parameter information
in manual MH01 is based on the standard MCH Series Modbus™ Drive. The differences between the drive
programming parameters described in the manual and those that exist in the MCH Series LonWorks®
Drive are explained in sections 3.1-3.4 herein.
3.1 Added Programming Parameters
60 SERIAL TIMEOUT This parameter makes the serial watchdog timeout period selectable.
(Section 3.5)
86 MOTOR RATED SPEED This parameter allows the user to enter the nominal speed of the motor
in RPM. This value is required for LON parameter nvoSpeedActRpm to
function properly. This parameter has a minimum value of 1 RPM and a
maximum value of 65000 RPM. The default is 1800 RPM.
89 MOTOR RATED FREQUENCY This parameter allows the user to enter the nominal frequency of the
motor in Hz. This value is required for many LON parameters (including
nviDrvSpeedStpt and nvoDrvSpeed) to function properly. This parameter
has a minimum value of 0.00 Hz and a maximum value of 650.00 Hz. The
default is 60.00 Hz.
125 APP REVISION This parameter allows the user to view the version of the application
software installed in the ABS_LON module. This parameter is used for
troubleshooting and to establish compatibility between the drive software
and the ABS_LON module. If this parameter is displaying a value of 0104
or 9999, contact AC Tech.
126 CPI REVISION This parameter allows the user to view the version of the common profile
interface software installed in the ABS_LON module. This parameter is
used for troubleshooting and to establish compatibility between the drive
software and the ABS_LON module. If this parameter is displaying a value
of 0124 or 9999, contact AC Tech.
127 CFG REVISION This parameter allows the user to view the version of the AC Tech
configuration software installed in the ABS_LON module. This parameter
is used for troubleshooting and to establish compatibility between the
drive software and the ABS_LON module. If this parameter is displaying a
value of 0001 or 9999, contact AC Tech.