Lenze MCH Series Drives - Manual (Page 12)

9 RG-MHLON
Drive Setup & Programming
3.3 Omitted Parameters and Selections
36 SLEEP THRESHOLD Sleep Mode functionality has not been added to the MCH Series LonWorks®
drive so these drive parameters do not exist.
37 SLEEP DELAY
38 SLEEP BANDWIDTH
41 ANALOG INPUT FILTER
52 TB14 OUT The following options have not been added to these parameters in the MCH
Series LonWorks® drive:
53 TB15 OUT
54 RELAY
INV MIN/MAX A
MIN ALARM
INV MIN ALARM
MAX ALARM
INV MAX ALARM
58 SERIAL ADDRESS The ABS_LON module only communicates with one MCH Drive so there is
no need for the drive to have a unique serial address and this parameter has
been removed.
3.4 Modified Parameters and Selections
8 ACCEL This parameter defines the time that it will take for the drive to ramp the motor up
from 0.00Hz to Drive Parameter #11 (Max Frequency).
9 DECEL This parameter defines the time that it will take for the drive to ramp the motor down
from Drive Parameter #11 (Max Frequency) to 0.00Hz.
24 AUTO SOURCE The default selection for this parameter is KEYPAD. This setting is required if the
drive speed is to be modified over the LonWorks® network.
32 HZ MULTIPLIER The default setting for this parameter is 30.00.
56 SERIAL LOSS The selections for this parameter are FAULT (default) and PRESET#3. The functionality
of this parameter is described in Section 3.5 Serial Communications Setup.