Lenze 8200 vector 15kW-30kW - Manual (Page 7)

Safety instructions
General safety and application notes for Lenze controllers
1
l
7 EDK82EV303 EN 1.0
1 Safety instructions
1.1 General safety and application notes for Lenze controllers
(in accordance with Low−Voltage Directive 2006/95/EC)
For your personal safety
Lenze controllers (frequency inverters, servo inverters, DC speed controllers) and the
accessory components can include live and rotating parts − depending on their type of
protection − during operation. Surfaces can be hot.
Non−authorised removal of the required cover, inappropriate use, incorrect installation or
operation, create the risk of severe injury to persons or damage to material assets.
More information can be obtained from the documentation.
Within the controller there are high energies. Therefore always wear personal protective
equipment when working on the live controller (body protection, headgear, eye
protection, ear protection, hand guard).
All operations concerning transport, installation, and commissioning as well as
maintenance must be carried out by qualified, skilled personnel (IEC 364 and CENELEC HD
384 or DIN VDE 0100 and IEC report 664 or DIN VDE 0110 and national regulations for the
prevention of accidents must be observed).
According to this basic safety information, qualified, skilled personnel are persons who are
familiar with the assembly, installation, commissioning, and operation of the product and
who have the qualifications necessary for their occupation.
Application as directed
Drive controllers are components which are designed for the installation into electrical
systems or machinery. They are not to be used as domestic appliances, but as components
only for industrial or professional purposes according to EN 61000−3−2.
When installing the controllers into machines, commissioning (i.e. starting of operation as
directed) is prohibited until it is proven that the machine complies with the regulations of
the EC Directive 98/37/EC (Machinery Directive); EN 60204 must be observed.
Commissioning (i.e. starting of operation as directed) is only allowed when there is
compliance with the EMC Directive (89/336/EEC).
The controllers meet the requirements of the Low−Voltage Directive 73/23/EEC. The
harmonised standard EN 61800−5−1 applies to the controllers.
The technical data and information on connection conditions must be obtained from the
nameplate and the documentation. They must be observed in any case.
Warning: Drive controllers are products that can be used in drive systems of category 2
according to EN 61800−3. These products can cause radio interferences in residential areas.
In this case, special measures are required.
Transport, storage
Please observe the notes on transport, storage and appropriate handling.
Observe the climatic conditions according to the technical data.