Lenze 8200 vector 15kW-30kW - Manual (Page 12)

Parameter setting
Parameter setting with E82ZBC keypad
Installation and commissioning
2
l
12 EDK82EV303 EN 1.0
2 Parameter setting
2.1 Parameter setting with E82ZBC keypad
Description
The keypad is available as an accessory. A full description of the keypad can be obtained
from the Instructions included in the keypad delivery.
Plugging in the keypad
It is possible to plug the keypad into the AIF interface or remove it during operation.
As soon as the keypad is supplied with voltage, it carries out a self−test. The keypad is ready
for operation if it is in display mode.
2.1.1 Installation and commissioning
„
E82ZWLxxx
E82ZBB
E82ZBC

‚
ƒ
z
y
w x
v
t
u
s
88888
8888 888 8 a b c d e
j g f k i h PS  ‚ m n o p q r
Hi Hz %sh rpm °C Ω
m A V Lo
z
y
w x
v
t
u
s
888 00
0050 000 1 a b c d e
j g f k i h PS  ‚ m n o p q r
Hi Hz %sh rpm °C Ω
m A V Lo
z
y
w x
v
t
u
s
888 00
0050 000 1 a b c d e j g f k i h PS  ‚ m n o p q r
Hi Hz %sh rpm °C Ω
m A V Lo
8888
8 8888 888 8 a b c d
e
j g f k i h PS
 ‚m n op q r
Hi
Hz %sh rpm °C Ω m A V
Lo
z
y
w x v
t
u
s
88888 8888 888 8 a b c d e j g f k i h PS  ‚m n op q r Hi Hz %sh rpm °C Ω m A V Lo
z
y w x
v
t
u
s
888 00
0050 000
a b c d e
j g f k i h PS 
‚ m n o p
q r
Hi Hz
%sh
rpm
°C Ω
m
A V
Lo
0
1
2
3
E82ZBC018
 Connect keypad to the AIF interface on the front of the standard device.
It is possible to connect the keypad and remove it during operation.
‚ As soon as the keypad is supplied with voltage, it carries out a short self−test.
ƒ The keypad is ready for operation, if it displays the "Disp" mode:
0 Current state of the standard device
1 Parameter set activated via terminal
2 Memory location 1 of the user menu (C0517):
Code number, subcode number, and current value
3 Current value in % of the status display defined in C0004
„ Press x to leave the "Disp" mode