Lenze E94APNE - Manual (Page 36)

Technical data
General data and operating conditions
3
l
36 EDK94PNE36 DE/EN/FR/ES/IT 3.1
3 Technical data
3.1 General data and operating conditions
Conformity and approval
Conformity
CE 2006/95/EC Low−Voltage Directive
Approval
In preparation: UL UL 508C Industrial Control Equipment, file no. 132659
Supply system data
Supply forms With earthed
*
point
Unrestricted use
IT systems Unrestricted use
Observe instructions about special measures concerning the
connected axis controllers!
Noise emission EN 61800−3 Conducted: cannot be specified because dependent on the
conditions present in the interconnected system
Radiation: category C3
Noise immunity (according to requirements of EN 61800−3)
Electrostatic discharge
(ESD) EN 61000−4−2 8 kV for air discharge,
4 kV for contact discharge to housing
Radio frequency
Conducted EN 61000−4−6 150 kHz ... 80 MHz, 10 V/m 80 % AM (1 kHz)
Radiation (housing) EN 61000−4−3 80 MHz ... 1000 MHz, 10 V/m 80 % AM (1 kHz)
Protection of persons and device protection
Enclosure EN 60529 IP 20
Not in the wire range of
the terminals on the
motor side
NEMA 250 Protection against contact to
type 1
Insulation resistance EN 61800−5−1 Overvoltage category III
Derating at and above 2000 m AMSL: overvoltage category II
Isolation of control circuits EN 61800−5−1 Safe mains isolation through double/reinforced insulation.
Short−circuit strength EN 61800−5−1 DC−bus connection: not short−circuit−proof
Brake resistor connection: full
Control connections: full
Discharge current EN 61800−5−1 > 3.5 mA Observe regulations and
safety instructions!
Cyclic mains switching Cyclic mains switching of five times in five minutes is fully
permissible.
Mounting conditions
Mounting place In the control cabinet
Mounting position Vertical
Mounting clearances
Above/below
³ 80 mm / ³ 120 mm
Observe the device−related
notes on mounting.
To the sides Side−by−side mounting without
any clearance