Lenze SMD 0-25kW-4-0kW - Manual (Page 19)

Lenze 13435747 EDBSX03 v17 EN, DE, FR, IT, ES 17
Commissioning
Code Possible Settings
IMPORTANT
No. Name Lenze Selection
c70
Configuration TRIP
reset (error reset)
0 0 TRIP reset after LOW-HIGH
change at terminal 28, mains
switching, or after LOW-HIGH
change at digital input “TRIP reset”
1 Auto-TRIP reset • Auto-TRIP reset after the time set in
c71
• More than 8 errors in 10 minutes will
trigger rSt fault
WARNING!
Automatic starting/restarting may cause damage to equipment and/or injury to
personnel! Automatic starting/restarting should only be used on equipment that is
inaccessible to personnel.
c71
Auto-TRIP reset delay 0.0 0.0 {s} 60.0 See c70
c78
Operating time
counter
Display
Total time in status “Start”
0...999 h: format xxx
1000...9999 h: format x.xx (x1000)
10000...99999 h: format xx.x (x1000)
c79
Mains connection
time counter
Display
Total time of mains = on
c81
PI setpoint 0.0 c86 c87
c82
S-ramp integration
time
0.0 0.0 {s} 50.0 • c82 = 0.0: Linear accel/decel ramp
• c82 > 0.0: Adjusts S-ramp curve for
smoother ramp
c86
Minimum feedback 0.0 0.0 999 • Select feedback signal at C34
• If feedback is reverse-acting, set
c86>c87
c87
Maximum feedback 100 0.0 999
d25
PI setpoint accel/
decel
5.0 0.0 {s} 999 Sets rate of change for PI setpoint
d38
PI mode 0 0 PI disabled
1 PI enabled: normal-acting
When feedback (terminal 8) exceeds
setpoint, speed decreases
2 PI enabled: reverse-acting When feedback (terminal 8) exceeds
setpoint, speed increases
d46
Feedback minimum
alarm
0.0 0.0 999
See C08, selections 9 and 10
d47
Feedback maximum
alarm
0.0 0.0 999