Labnet Z206A High Capacity, Compact Research Centrifuge - Manual (Page 5)

Page 5 of 24 INSTRUCTION MANUAL Z 206 A © HERMLE Labortechnik GmbH
1 PRODUCT DESCRIPTION
1.1.1.4 Included Accessories
Following parts are supplied as accessories with each centrifuge:
• 1 Instruction manual
1.1.1.5 Warranty
The centrifuge has been subjected to thorough testing and quality control procedures.
In the unlikely case of any manufacturing faults occurring, the centrifuge and rotors are covered by
warranty for a period of two year from date of delivery.
This warranty becomes invalid in case of mishandling, negligence, and further in case of
usage of inappropriate spare parts and / or accessories, as well as any unauthorized modification
of the unit.
Technical modification rights are reserved by the manufacturer in respect to technical
improvement.
1.2 Installation
1.2.1 Installation of the centrifuge
1.2.1.1 Unpacking the centrifuge
Model Z 206 A is supplied in a carton.
Remove the strap retainer, open the carton and remove the centrifuge. The instruction
manual should always be kept with the centrifuge.
1.2.1.2 Space requirements
The centrifuge should be installed on an even and solid surface, if possible on a laboratory
cabinet / table or some other solid vibration free surface.
In order to enable a safe and smooth operation, level the centrifuge with a levelling device.
The centrifuge must be placed in a way, that there is a minimum space of 30 cm on each side of the unit
in order to ensure the necessary heat dissipation.
Do not place the centrifuge next to a window or a heater, where it could be disposed to excessive heat,
as the performance of the unit is based on an ambient temperature of 23°C.
Safety regulations require that the safety area of 30 cm around the unit is marked in order to indicate
that neither hazardous substances nor persons should be within this area during centrifugation.